Pages: [1] :: one page |
|
Author |
Thread Statistics | Show CCP posts - 0 post(s) |
Jiess Santos
|
Posted - 2008.08.19 07:01:00 -
[1]
I've read both Kazuo Ishiguro's POS Lab guide and Eve-Guide's without a clear solution / answer to my specific problem.
Our small corporation just started running a POS with labs in Empire space. Corcord ensuring our safety, we're keeping most plans in the corporate hangar of the mobile lab. We've set up our POS in a NPC-station-less system.
I've just picked up Scientific networking to level 2 (5 jumps). Even with most Corp roles, we didn't find a way to start a research job without actually being 1500m from the Lab. I can deliver completed jobs without a problem, yet starting one can't seem to work.
When in the station's system the corp blueprint tab in SNI tells me to get closer. In a different (in range) system the corp blueprint tab doesn't even detect our plans in the oven. If I go through the installation tab, the lab does exists, but farther in the installation process I cannot select the corp hangar in the find blueprint screen.
Is there a way to actually access remotely those plans or are we SOL and need to move the entire operation in order to have a NPC starbase in the vincity? Or did I just waste a good 6,75M of my hard-earned isk...
Thanks in advance for the following answers and apologies if this particular problem was solved not so long ago (more than 5 pages in the SNI forum ) |
RaTTuS
BIG Libertas Fidelitas
|
Posted - 2008.08.19 07:47:00 -
[2]
to start remote jobs you'll need to have the BPO in a corp hanger in a station in the system whee the POS is
|
Mona X
Caldari Polish Task Forces C0VEN
|
Posted - 2008.08.19 07:50:00 -
[3]
You have those BPOs in station or mobile lab? |
RaTTuS
BIG Libertas Fidelitas
|
Posted - 2008.08.19 07:53:00 -
[4]
he has them in the lab as it is a stationless system |
Venkul Mul
Gallente
|
Posted - 2008.08.19 08:01:00 -
[5]
For me it work perfectly.
Have you tried relogging after training the skill?
Check the range of your remote job too. Under the installation range, if you start from the Corp blueprint tab it start at a range of "current blueprint location", but if you aren't within 1.500 meters from the lab it will not work properly.
You need to change the range till you see the location. And it will not work if you are in a different region, even if it is only at 1 jump range.
|
Lord Fitz
Project Amargosa
|
Posted - 2008.08.19 11:15:00 -
[6]
Basically, you can't do this. The main reason is that as you found out, there is no way to remotely see the contents of any POS modules.
And you can't move the BPOs out of the POS, unless you put up a POS in a system with a station.
Also do note, that concord only ensures your safety until you are wardecced. So if you're not playing for a 24 hours you could come back and find your POS in reinforced, especially with a POS in a system without stations that screams 'we keep BPOs here'. At that point you can't remove the BPOs and may lose them all when the tower is destroyed. |
|
|
|
Pages: [1] :: one page |
First page | Previous page | Next page | Last page |