Pages: [1] :: one page |
|
Author |
Thread Statistics | Show CCP posts - 0 post(s) |
Sarabearrah
Caldari
|
Posted - 2008.09.22 12:27:00 -
[1]
Hello, I just got into a raven (minimun skills needed because of hulk training)for exploration of new belts to mine, rat killing and salvage. My question is, when a rat appears I go to lock target on it(in upper right overview)and it takes upwards of 30 to 50 seconds to target lock the rat. By the time I lock my scout drones have taken care of the rat. My Osprey targets rats extremely fast using the same basic launcher/rail guns that I have on the raven, so I am a bit confused as to why the raven is so slow to target. Can anyone please point me in the right direction as to what I need to skill on to reduce the target lock time in my raven. I have looked at all the skills raven vs osprey and I am guessing I need to up my battleship skill (now at level 2) seeing as I am at level 4 for the osprey.
Thank you.
|
Father Dibbles
Self Aggrandisement Society
|
Posted - 2008.09.22 12:38:00 -
[2]
Edited by: Father Dibbles on 22/09/2008 12:39:42 Two items:
Sensor Booster (med slot)(better than below) Signal Amplifier (low slot)(worse than above, but grants additional +total targets)
One skill:
Signature Analysis
Modules such as Warp Core Stabilisers & Cloaks will significantly reduce your ship's scan resolution (the figure which affects lock time). If you have either of those two modules fitted (I suspect you might do?) then removing them will make you lock a dam sight faster.
|
Grimpak
Gallente Trinity Nova Trinity Nova Alliance
|
Posted - 2008.09.22 12:40:00 -
[3]
also, remove warp stabs. ---
Quote: The more I know about humans, the more I love animals.
ain't that right. |
Sarabearrah
Caldari
|
Posted - 2008.09.22 13:08:00 -
[4]
Thank you everyone !
That fixed my problem. I did have the warp core stab installed, now removed. I also did the signature skill and added the sensor booster with script.
Me happy !!
|
DiseL
Dirt Nap Squad Dirt Nap Associates
|
Posted - 2008.09.22 19:56:00 -
[5]
Scan Resolution is what you should be looking at. The Raven has a very low scan resolution which equals slow lock times. For the most part the bigger the ship the lower the scan res which means slower lock time. Your Osprey will outlock the Raven even unfitted due to a higher scan res. Fitting warp stabs or a cloak has a tremendous negative effect on scan res. Sensor Boosters and Signal Amps have a positive effect of scan res.
|
Yennifer
Minmatar el'Huracan
|
Posted - 2008.09.22 20:05:00 -
[6]
Signature analysis skill lvl must be 5.. sometimes it can save life ;) [url=http://www.travian.ru/?uc=ru6_76194][/url] |
Sarabearrah
Caldari Rumspringa
|
Posted - 2008.09.22 20:22:00 -
[7]
Sooooo.....can I use a signal amp AND a sensor booster together? or a pair of either? It says using one or more of this module or similar modules that affect the same attribute on the ship will be penalized.
I am upping my sig analyze rank right now from 2 to 3.
Thank you all again for the answers.
|
Waxau
The Fated
|
Posted - 2008.09.22 22:24:00 -
[8]
Yes you can use two. Yes you will get an improvement. The penalisation does occur, but not to the extent of being a negative value. EG - You will always get an improvement. But not to the same extent the original one gave.
ps - from the sounds of it, you have a somewhat odd setup, if you're ratting the same rats as you did with your osprey, using the same weapons etc. Just pointing out :P You might want to look into it.
|
|
|
|
Pages: [1] :: one page |
First page | Previous page | Next page | Last page |